R&S NRP2, User Manual

Page: 354 / 437

Error Messages and Troubleshooting
R&S
®
NRP2
336 User Manual 1173.9157.02 ─ 03
8.2 SCPI-Specific Error Messages
The list below contains error messages that may occur in the instrument. Negative error
numbers are defined in the SCPI standard, positive error numbers identify device-specific
errors.
The left column of the following table gives the error code. In the right column, the text of
the error message displayed or entered in the error/event queue is printed in bold. An
additional explanation is given below this text.
8.2.1 No error
Error code "Error text returned upon queue query"
Explanations
0 "No error"
This message is displayed if the error queue is empty.
8.2.2 Command Error
Command errors; causes bit 5 in the ESR to be set.
Error code Error text returned upon queue query
Explanations
-100 "Command error"
Command faulty or invalid.
-101 "Invalid character"
The command contains a character which is invalid for that type.
-102 "Syntax error"
The command is invalid.
-103 "Invalid separator"
Command contains an illegal character where a separator is expected.
-104 "Data type error"
Command contains an invalid data element.
-108 "Parameter not allowed"
The command contains too many parameters.
-109 "Missing parameter"
The command contains fewer parameters than required.
-111 "Header separator error"
The header contains an illegal delimiter.
-112 "Program mnemonic too long"
The header contains more than 12 characters.
SCPI-Specific Error Messages