Remote Control - Commands
R&S
®
NRP2
202
User Manual 1173.9157.02 ─ 03
Command
Preset and *RST value
Remark
TRIG[1..4|:ALL]:HYST
<NRf>
Depending on sensor.
TRIG[1..4|:ALL]:LEV
<NRf>
Depending on sensor.
TRIG[1..4|:ALL]:MAST
ON | OFF
Depending on sensor.
TRIG[1..4|:ALL]:SLOP
POS | NEG
Depending on sensor.
TRIG[1..4|:ALL]:SOUR
IMM | HOLD | EXT |
INT | BUS
Depending on sensor.
UNIT<[1]..8>:POW
DBM
Logarithmic result scaling.
UNIT<[1]..8>:POW:RAT
DB
Logarithmic result scaling.
Usage:
Event
*SAV
<value>
SAV
e stores the current device state under the specified number.
Parameters:
<Value>
1 to 19
Available storage numbers for device setups.
Usage:
Event
*SRE
<value>
Setting command:
*SRE
S
ervice
R
equest
E
nable sets the service request enable register to the specified value.
Bit 6 (MSS mask bit) remains 0. This command determines under which conditions a
service request is generated.
Query:
*SRE
The query form
*SRE?
reads the contents of the service request enable register in dec-
imal form. Bit 6 is always 0.
Parameters:
<value>
0 to 255
*STB?
ST
atus
B
yte query reads out the contents of the status byte in decimal form.
Usage:
Query only
Common Commands to IEEE 488.2
Summary of Contents for NRP2
