Remote Control
R&S
®
NGE100B
79
User Manual 5601.1343.02 ─ 04
SYSTem:COMMunicate:WLAN[:STATe]
<arg0>
This command activates/deactivates or queries the enable state of the wireless inter-
face.
Available only if option R&S NGE-K102 is installed.
Parameters:
<arg0>
SYSTem:COMMunicate:WLAN:PASSword
<arg0>
This command defines the password string of the Access Point when the wireless
interface works as a client.
Available only if option R&S NGE-K102 is installed.
Parameters:
<arg0>
Usage:
Setting only
SYSTem:COMMunicate:WLAN:SSID
<arg0>
This command defines or queries the SSID string of the access point when the wire-
less interface works as a client.
Available only if option R&S NGE-K102 is installed.
Parameters:
<arg0>
6.5.3
Firmware Update
DIAGnostic:SERVice:FWUP
<arg0>
Starts instrument firmware update remotely.
For more information, see
Chapter 5.7.6, "Updating the Firmware"
Parameters:
<arg0>
Example:
DIAGnostic:SERVice:FWUP
"NGE100FWRelease.tar.gz.enc"
Usage:
Setting only
6.5.4
HCOPY
HCOPy:DATA?
This command queries current screen content. BMP format is supported.
Remote Control - Commands