R&S FSW Series, User Manual

Page: 487 / 1450

Common Measurement Settings
R&S
®
FSW
487 User Manual 1173.9411.02 ─ 43
To define an external trigger:
1. Connect an external device that will provide the trigger signal to one of the TRIG-
GER INPUT / OUTPUT connectors on the R&S FSW (for details see the R&S FSW
"Getting Started" manual).
2. In the "Trigger And Gate" dialog box, define the "Trigger Source" = "External".
3. If you are using the variable TRIGGER 2 INPUT / OUTPUT connector, you must
define its use as an input connector. In the "Trigger In/Out" tab of the "Trigger And
Gate" dialog box, set the corresponding trigger to "Input".
(Note: Trigger 2 is on the front panel, Trigger 3 is on the rear panel.)
4. Configure the external trigger as described for the other power triggers.
To define a power trigger:
1. In the "Trigger And Gate" dialog box, define the "Trigger Source" = "IF Power".
Alternatively, define "Trigger Source" = "Video". The video signal corresponds to
the envelope of the IF signal: it has been processed by the resolution and video
filters and the selected detector.
2. Define the "Trigger Level": the power level at which the measurement will start.
For a "Video" trigger source you can move the level line graphically to define the
level. If you define the value numerically, you must enter a percentage of the full
diagram height as the level.
3. Define whether the signal must cross the trigger level on a falling or on a rising
edge ("Slope") to trigger the measurement.
4. To start the measurement with a time delay, define a "Trigger Offset".
5. To reject triggers due to noise or jittering in the signal, define a "Hysteresis" that is
larger than the expected noise or jittering. After the previous trigger, the signal
must exceed this threshold before the next level crossing triggers a new measure-
ment.
6. To skip multiple triggers in a burst, define a "Holdoff" time that must pass between
two triggers. The holdoff time should be slightly larger than the burst.
8.6.2 Gating
● Gated Measurements ............................................................................................488
● Gate Settings ........................................................................................................ 491
● Continuous Gate Settings ..................................................................................... 493
● Gate Source Settings ............................................................................................494
● How to Configure a Gated Measurement ..............................................................496
Trigger and Gate Configuration