R&S FSW Series, User Manual

Page: 288 / 1450

Measurements and Results
R&S
®
FSW
288 User Manual 1173.9411.02 ─ 43
●
The unit is dB.
For details on transducers, see Chapter 12.3.1, "Basics on Transducer Factors" ,
on page 675.
Remote command:
[SENSe:]LIST:RANGe<ri>:TRANsducer
on page 961
Limit Check
Activates or deactivates the limit check for all ranges.
For details on limit checks, see Chapter 7.7.3.2, "Limit Lines in Spurious Measure-
ments" , on page 283.
"ABSOLUTE"
Signal is checked against absolute limit values
"NONE" No limit check is performed.
Remote command:
[SENSe:]LIST:RANGe<ri>:LIMit:STATe
on page 959
CALCulate<n>:LIMit<li>:FAIL?
on page 1224
Abs Limit Start/ Abs Limit Stop
Sets an absolute limit value at the start or stop frequency of the range [dBm].
Remote command:
[SENSe:]LIST:RANGe<ri>:LIMit:STARt
on page 959
[SENSe:]LIST:RANGe<ri>:LIMit:STOP
on page 959
Insert before Range/ Insert after Range
Inserts a new range to the left of the currently focused range (before) or to the right
(after). The range numbers of the currently focused range and all higher ranges are
increased accordingly. The maximum number of ranges is 30.
Delete Range
Deletes the currently focused range. The range numbers are updated accordingly.
7.7.4.2 Adjusting the X-Axis to the Range Definitions
Access : "Overview" > "Select Measurement" > "Spurious Emissions" > "Adjust X-Axis"
The frequency axis of the measurement diagram can be adjusted automatically so that
the span of all sweep list ranges corresponds to the displayed span. Thus, the x-axis
range is set from the start frequency of the first sweep range to the stop frequency of
the last sweep range.
Remote command:
[SENSe:]LIST:XADJust
on page 963
7.7.4.3 List Evaluation
Access : "Overview" > "Select Measurement" > "Spurious Emissions" > "List Evalua-
tion"
Spurious Emissions Measurement