R&S FSW Series, User Manual, Page: 1220 / 1450

Remote Commands
R&S
®
FSW
1220 User Manual 1173.9411.02 ─ 43
CALCulate<n>:LIMit<li>:UPPer:SHIFt <Distance>
This command moves a complete upper limit line vertically.
Compared to defining an offset, this command actually changes the limit line definition
points by the value you define.
Suffix:
<n>
.
irrelevant
<li> Limit line
Parameters:
<Distance> Defines the distance that the limit line moves.
The unit depends on
CALCulate<n>:LIMit<li>:UNIT
on page 1218.
Manual operation: See "Shift y" on page 569
CALCulate<n>:LIMit<li>:UPPer:SPACing <InterpolType>
This command selects linear or logarithmic interpolation for the calculation of an upper
limit line from one horizontal point to the next.
Suffix:
<n>
.
Window
<li> Limit line
Parameters:
<InterpolType> LINear | LOGarithmic
*RST:
LIN
Manual operation: See "Y-Axis" on page 568
CALCulate<n>:LIMit<li>:UPPer:STATe <State>
This command turns an upper limit line on and off.
Before you can use the command, you have to select a limit line with
CALCulate<n>:
LIMit<li>:NAME
on page 1217.
Suffix:
<n>
.
irrelevant
<li> Limit line
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Manual operation: See "Visibility" on page 565
Analyzing Measurements (Basics)