R&S FSW-K7, User Manual

Page: 73 / 407

Configuration
R&S
®
FSW-K7
73 User Manual 1173.9240.02 ─ 23
Using the TTL interface allows for considerably higher measurement rates than pure
GPIB control, because the frequency stepping of the R&S
FSW is directly coupled with
the frequency stepping of the generator.
For more information on TTL synchronization, see "TTL synchronization" on page 42.
For an overview of which generators support TTL synchronization see Chapter 4.7.4.2,
"Overview of Supported Generators" , on page 35.
Remote command:
SYSTem:COMMunicate:RDEVice:GENerator:LINK
on page 234
GPIB Address / TCP/IP Address
For LAN connections: TCP/IP address of the signal generator
For GPIB connections: GPIB address of the signal generator.
Remote command:
SYSTem:COMMunicate:GPIB:RDEVice:GENerator:ADDRess
on page 233
SYSTem:COMMunicate:TCPip:RDEVice:GENerator:ADDRess
on page 234
Reference
Selects the internal R&S FSW or an external frequency reference to synchronize the
R&S FSW with the generator (default: internal).
Remote command:
SOURce:EXTernal:ROSCillator[:SOURce]
on page 233
Edit Generator Setup File
Displays the setup file for the currently selected Generator Type in read-only mode in
an editor.
Although the existing setup files are displayed in read-only mode in the editor, they can
be saved under a different name (using "File > SaveAs").
Be careful, however, to adhere to the required syntax and commands. Errors are only
detected and displayed when you try to use the new generator (see also
Chap-
ter 4.7.4.8, "Displayed Information and Errors" , on page 43).
For details, see Chapter 4.7.4.3, "Generator Setup Files" , on page 37.
Frequency Min. / Frequency Max.
For reference only: Lower and upper frequency limit for the generator.
Level Min. / Level Max.
For reference only: Lower and upper power limit for the generator.
Input and Frontend Settings