R&S FSW-K7, User Manual

Page: 358 / 407

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
358 User Manual 1173.9240.02 ─ 23
Parameters:
<LimitLinePoints> Variable number of level values.
Note that the number of vertical values has to be the same as
the number of horizontal values set with
CALCulate<n>:
LIMit<k>:CONTrol[:DATA]
. If not, the R&S FSW either adds
missing values or ignores surplus values.
The unit depends on
CALCulate<n>:LIMit<k>:UNIT
on page 360.
*RST:
Limit line state is OFF
Manual operation: See "Data points" on page 159
CALCulate<n>:LIMit<k>:LOWer:MARGin <Margin>
This command defines an area around a lower limit line where limit check violations
are still tolerated.
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<Margin> numeric value
*RST: 0
Default unit: dB
Manual operation: See "Margin" on page 159
CALCulate<n>:LIMit<k>:LOWer:MODE <Mode>
This command selects the vertical limit line scaling.
Suffix:
<n>
.
Window
<k> Limit line
Parameters:
<Mode> ABSolute
Limit line is defined by absolute physical values.
The unit is variable.
RELative
Limit line is defined by relative values related to the reference
level (dB).
*RST:
ABSolute
Manual operation: See "X-Axis" on page 159
CALCulate<n>:LIMit<k>:LOWer:OFFSet <Offset>
This command defines an offset for a complete lower limit line.
Analyzing Results