R&S FSW-K7, User Manual

Page: 356 / 407

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
356 User Manual 1173.9240.02 ─ 23
Parameters:
<LimitLinePoints> Variable number of x-axis values.
Note that the number of horizontal values has to be the same as
the number of vertical values set with
CALCulate<n>:
LIMit<k>:LOWer[:DATA]
or
CALCulate<n>:LIMit<k>:
UPPer[:DATA]
. If not, the R&S FSW either adds missing val-
ues or ignores surplus values.
The unit is Hz or s.
*RST:
-
Manual operation: See "Data points" on page 159
CALCulate<n>:LIMit<k>:CONTrol:DOMain <SpanSetting>
This command selects the domain of the limit line.
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<SpanSetting> FREQuency | TIME
*RST:
FREQuency
Manual operation: See "X-Axis" on page 159
CALCulate<n>:LIMit<k>:CONTrol:MODE <Mode>
This command selects the horizontal limit line scaling.
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<Mode> ABSolute
Limit line is defined by absolute physical values (Hz or s).
RELative
Limit line is defined by relative values related to the center fre-
quency (frequency domain) or the left diagram border (time
domain).
*RST:
ABSolute
CALCulate<n>:LIMit<k>:CONTrol:OFFSet <Offset>
This command defines an offset for a complete limit line.
Compared to shifting the limit line, an offset does not actually change the limit line defi-
nition points.
Analyzing Results