R&S FSW-K7, User Manual

Page: 323 / 407

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
323 User Manual 1173.9240.02 ─ 23
Example: CALC:DELT:AOFF
Turns off all delta markers.
Usage: Event
CALCulate<n>:DELTamarker<m>:LINK <State>
This command links delta marker <m> to marker 1.
If you change the horizontal position (x-value) of marker 1, delta marker <m> changes
its horizontal position to the same value.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 1 | 0
*RST:
0
Example: CALC:DELT2:LINK ON
Manual operation: See "Linking to Another Marker" on page 140
CALCulate<n>:DELTamarker<m>:LINK:TO:MARKer<m> <State>
This command links delta marker <m1> to any active normal marker <m2>.
If you change the horizontal position of marker <m2>, delta marker <m1> changes its
horizontal position to the same value.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 1 | 0
*RST:
0
Example: CALC:DELT4:LINK:TO:MARK2 ON
Links the delta marker 4 to the marker 2.
Manual operation: See "Linking to Another Marker" on page 140
CALCulate<n>:DELTamarker<m>:MODE <Mode>
This command defines whether the position of a delta marker is provided as an abso-
lute value or relative to a reference marker.
Note that when the position of a delta marker is queried , the result is always an abso-
lute value (see
CALCulate<n>:DELTamarker<m>:X
on page 325)!
Analyzing Results