R&S FSW-K7, User Manual

Page: 322 / 407

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
322 User Manual 1173.9240.02 ─ 23
CALCulate<n>:MARKer<m>:Y?
This command queries the position of a marker on the y-axis.
If necessary, the command activates the marker first.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
INITiate<n>:CONTinuous
on page 295.
If the analog demodulator (option Analog Demodulation, R&S FSW–K7) is activated,
the query result is output in the following units in the specified window:
Result display Output unit
AM %
FM Hz
PM rad/deg (defined with
UNIT<n>:ANGLe
on page 279)
RF dB (Range Log or Range Linear %)
% (Range Linear dB)
Suffix:
<n>
.
Window
<m> Marker
Return values:
<Result> Result at the marker position.
Example: INIT:CONT OFF
Switches to single measurement mode.
CALC:MARK2 ON
Switches marker 2.
INIT;*WAI
Starts a measurement and waits for the end.
CALC:MARK2:Y?
Outputs the measured value of marker 2.
Usage: Query only
Manual operation: See "Marker Table" on page 22
See "Marker Peak List" on page 23
CALCulate<n>:DELTamarker<m>:AOFF
This command turns off all delta markers.
Suffix:
<n>
.
Window
<m> irrelevant
Analyzing Results