R&S FSW-K7, User Manual

Page: 198 / 407

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
198 User Manual 1173.9240.02 ─ 23
Manual operation: See "Conversion loss" on page 58
[SENSe:]MIXer:LOSS:TABLe[:LOW] <FileName>
This command defines the file name of the conversion loss table to be used for the low
(first) range.
Parameters:
<FileName> String containing the path and name of the file.
Example: MIX:LOSS:TABL 'mix_1_4'
Specifies the conversion loss table mix_1_4 .
Manual operation: See "Conversion loss" on page 58
[SENSe:]MIXer:LOSS[:LOW] <Average>
This command defines the average conversion loss to be used for the entire low (first)
range.
Parameters:
<Average> numeric value
Range:
0 to 100
*RST: 24.0 dB
Default unit: dB
Example: MIX:LOSS 20dB
Manual operation: See "Conversion loss" on page 58
[SENSe:]MIXer:PORTs <PortType>
This command specifies whether the mixer is a 2-port or 3-port type.
Parameters:
<PortType> 2 | 3
*RST: 2
Example: MIX:PORT 3
Manual operation: See "Mixer Type" on page 57
[SENSe:]MIXer:RFOVerrange[:STATe] <State>
If enabled, the band limits are extended beyond "RF Start" and "RF Stop" due to the
capabilities of the used harmonics.
Parameters:
<State> ON | OFF | 1 | 0
*RST:
0
Manual operation: See "RF Overrange" on page 57
Configuring the Measurement