R&S FSVA3000 Series, User Manual

Page: 746 / 1268

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
746 User Manual 1178.8520.02 ─ 01
Example: ABOR;:INIT:IMM
Aborts the current measurement and immediately starts a new
one.
Example: ABOR;*WAI
INIT:IMM
Aborts the current measurement and starts a new one once
abortion has been completed.
Usage: Event
INITiate<n>:CONMeas
This command restarts a (single) measurement that has been stopped (using
ABORt
)
or finished in single sweep mode.
The measurement is restarted at the beginning, not where the previous measurement
was stopped.
Suffix:
<n>
.
irrelevant
Example: INIT:CONT OFF
Switches to single sweep mode.
DISP:WIND:TRAC:MODE AVER
Switches on trace averaging.
SWE:COUN 20
Setting the sweep counter to 20 sweeps.
INIT;*WAI
Starts the measurement and waits for the end of the 20 sweeps.
INIT:CONM;*WAI
Continues the measurement (next 20 sweeps) and waits for the
end.
Result: Averaging is performed over 40 sweeps.
Manual operation: See " Continue Single Sweep " on page 388
INITiate<n>:CONTinuous <State>
This command controls the sweep mode for an individual channel.
Note that in single sweep mode, you can synchronize to the end of the measurement
with *OPC, *OPC? or *WAI. In continuous sweep mode, synchronization to the end of
the measurement is not possible. Thus, it is not recommended that you use continuous
sweep mode in remote control, as results like trace data or markers are only valid after
a single sweep end synchronization.
For details on synchronization see Chapter 13.1.6, "Command Sequence and Syn-
chronization" , on page 663.
Suffix:
<n>
.
irrelevant
Parameters:
<State> ON | OFF | 0 | 1
Configuring and Performing Measurements