R&S FSV3000 Series, User Manual

Page: 56 / 307

Configuration
R&S
®
FSV/A3000 I/Q Analyzer
56 User Manual 1178.8536.02 ─ 01
Common Mode Offset / Diff. Mode Offset / P Offset / N Offset /
Sets the offset for the probe, depending on the used mode (CM and DM mode both
use the "Common Mode Offset"). The setting is only available if a differential (R&S RT-
ZD) or modular (R&S RT-ZM) probe is connected to the R&S
FSV/A.
If the probe is disconnected, the offset of the probe is reset to 0.0 V.
Note: If the offset for DM-mode or CM-mode is changed, the offsets for the P-mode
and N-mode are adapted accordingly, and vice versa.
Remote command:
[SENSe:]PROBe<pb>:SETup:CMOFfset
on page 144
[SENSe:]PROBe<pb>:SETup:DMOFfset
on page 145
[SENSe:]PROBe<pb>:SETup:NMOFfset
on page 146
[SENSe:]PROBe<pb>:SETup:PMOFfset
on page 147
Attenuation
Defines the attenuation applied to the input at the probe. This setting is only available
for modular probes.
"10:1" Attenuation by 20 dB
"2:1" Attenuation by 6 dB
Remote command:
[SENSe:]PROBe<pb>:SETup:ATTRatio
on page 144
Microbutton Action
Active Rohde & Schwarz probes (except for R&S RT-ZS10E) have a configurable
microbutton on the probe head. By pressing this button, you can perform an action on
the instrument directly from the probe.
Select the action that you want to start from the probe:
"Run Single" Starts one data acquisition.
"No Action" Prevents unwanted actions due to unintended usage of the microbut-
ton.
Remote command:
[SENSe:]PROBe<pb>:SETup:MODE
on page 145
5.3.1.4 External Generator Control Settings
Access : [INPUT/OUPUT] > "External Generator Config"
The "External Generator" settings are available if the R&S FSV/A External Generator
Control option is installed. For each measurement channel, you can configure one
external generator. To switch between different configurations, define multiple mea-
surement channels.
For more information on external generator control, see Chapter 4.3, "Basics on Exter-
nal Generator Control" , on page 24.
● Interface Configuration Settings ..............................................................................57
● Measurement Settings ............................................................................................ 59
● Source Calibration Functions ..................................................................................61
Data Input and Output Settings