R&S FSV-K7, Operating Manual, Page: 184 / 262

Analog Demodulation Option R&S FSV–K7
R&S
®
FSV-K7/K7S
184 Operating Manual 1176.7561.02 ─ 06
Parameters:
<State> ON | OFF
*RST: OFF
Example: OUTP:DIQ ON
Mode: ADEMOD, IQ, VSA
OUTPut:IF[:SOURce] <Source>
This command selects the source of the IF output.
Parameters:
<Source> IF
Outputs the intermediate frequency.
VIDeo
Outputs the video signal (200 mV).
*RST:
IF
Example: OUTP:IF VID
Selects the video signal for the IF output connector.
Manual operation: See "Video Output" on page 76
OUTPut:TRIGger <PortLevel>
This command selects level of the Trigger Out port. Thus, you can trigger an additional
device via the external trigger port, for example.
Parameters:
<PortLevel> LOW | HIGH
*RST:
LOW
Example: OUTP:TRIG HIGH
Manual operation: See "Trigger Out" on page 77
2.3.10.5 Other Commands
FORMat[:DATA] <Format>
This command selects the data format for the data transmitted from the
R&S
FSVA/FSV to the controlling computer. It is used for the transmission of trace
data. The data format of trace data received by the instrument is automatically recog-
nized, regardless of the format which is programmed.
(See also
TRACe<n>[:DATA]?
on page 160).
Parameters:
<Format> ASCii
ASCII data are transmitted in plain text, separated by commas.
Remote Commands of the Analog Demodulation (R&S FSV–K7)