R&S FSPN, User Manual

Page: 343 / 555

Remote Control
R&S
®
FSPN
343 User Manual 1179.4363.02 ─ 01
Example: //Use a different DC power setup for each active measurement
channel
SOUR:VOLT:CHAN:COUP OFF
Manual operation: See "Coupling the output configuration across measurement
channels" on page 124
SOURce:VOLTage:CONTrol<i>:LEVel:AMPLitude <Voltage>
This command defines the output voltage for the V
tune
source.
Suffix:
<i>
.
1..n
irrelevant
Parameters:
<Voltage> <numeric value>
Range:
-10 to 28
*RST: 0
Default unit: V
Example: //Defines an output voltage of 1 V on the V
tune
source
SOUR:VOLT:CONT:LEV:AMPL 1
Manual operation: See "Defining the output level" on page 125
SOURce:VOLTage:CONTrol<i>:LEVel:LIMit:HIGH <Voltage>
This command defines the maximum voltage that may be supplied by the V
tune
source.
Suffix:
<i>
.
1..n
irrelevant
Parameters:
<Voltage> <numeric value>
Range:
-10 to 28
*RST: 0
Default unit: V
Example: //Defines a maximum voltage of 5 V
SOUR:VOLT:CONT:LEV:LIM:HIGH 5
Manual operation: See "Defining the output level" on page 125
SOURce:VOLTage:CONTrol<i>:LEVel:LIMit:LOW <Voltage>
This command defines the minimum voltage that may be supplied by the V
tune
source.
Suffix:
<i>
.
irrelevant
Common Measurement Settings