R&S FSMR3000, User Manual, Page: 458 / 733

Remote Commands
R&S
®
FSMR3000
458 User Manual 1179.0116.02 ─ 02
[SENSe:]FILTer<n>:LPASs:FREQuency[:ABSolute] <Frequency>
This command selects the absolute low pass filter type for the specified evaluation
For details on the low pass filter refer to "Low Pass" on page 163.
Suffix:
<n>
.
Window
Parameters:
<Frequency> 3kHz | 15kHz | 150kHz
*RST:
15kHz
Default unit: HZ
Example: FILT:LPAS:FREQ 150kHz
Selects the low pass filter for the demodulation bandwidth range
from 400 kHz to 16 MHz.
Manual operation: See "Low Pass" on page 163
[SENSe:]FILTer<n>:LPASs:FREQuency:MANual <Frequency>
This command selects the cutoff frequency of the low pass filter for the specified evalu-
ation.
For details on the low pass filter refer to "Low Pass" on page 163.
Suffix:
<n>
.
Window
Parameters:
<Frequency> numeric value
Range:
0 to 3 MHz
*RST: 15kHz
Default unit: HZ
Example: FILT:LPAS:FREQ:MAN 150kHz
The AF results are restricted to frequencies lower than 150 kHz.
Manual operation: See "Low Pass" on page 163
[SENSe:]FILTer<n>:LPASs:FREQuency:RELative <Frequency>
This command selects the relative low pass filter type for the specified evaluation
For details on the low pass filter refer to "Low Pass" on page 163.
Suffix:
<n>
.
Window
Parameters:
<Frequency> 5PCT | 10PCT | 25PCT
*RST:
25PCT
Default unit: PCT
Configuring the Measurement