R&S FSMR3000, User Manual

Page: 299 / 733

General Instrument Setup
R&S
®
FSMR3000
299 User Manual 1179.0116.02 ─ 02
To save the new password, select "Save". The password dialog for the next user is dis-
played, until you have been prompted to change the password all user accounts.
If you cancel the dialog without changing the password, the password dialog for the
next user is displayed, until you have been prompted to change the password all user
accounts. Although it is possible to continue in secure user mode without changing the
passwords (and you will not be prompted to do so again), it is strongly recommended
that you do define a more secure password for all users.
By default, the password characters are not displayed to ensure confidentiality during
input. To display the characters, select "Show password".
To display the onscreen keyboard, select "Keyboard".
Number block behavior
Defines the default behavior of the keypad on the front panel of the R&S FSMR3 for
text input. Depending on the type of values you most frequently enter using the key-
pad, a different default is useful.
"123" Numeric values are entered when you press a key on the keypad.
To enter alphanumeric values, use an external or the on-screen key-
board, or switch this setting.
"ABC" (Default)
Every key on the keypad represents several characters and one num-
ber. If you press the key multiple times in quick succession, you tog-
gle through the symbols assigned to the key. For the assignment,
refer to
Table 4-10 .
10.4.6 Signal Generator Settings
Access : [Setup] > "System Configuration" > "Signal Generator"
These settings configure a connected signal generator that can then be used for vari-
ous tasks, for example for external generator control or NPR measurements.
IP Address or Computer name of Signal Generator ................................................... 300
└ 123/ABC ........................................................................................................300
└ Password ...................................................................................................... 300
Test Connection .......................................................................................................... 300
Connect/Disconnect .................................................................................................... 300
View Signal Generator ................................................................................................ 300
System Configuration Settings