Spectrum Analyzer
R&S FS300
E-1007.9900.15
6-132
Operating manual, 02/2006
6.2.5.1.1 Activating
Traces
Use
The measured values for the input signal can be displayed using two different
traces (Trace 1 and Trace 2). However, only one trace is active and can be
used at any one time. The other trace is frozen and displayed. This means
that the two traces can be compared.
Activating
Trace 1
When you switch on the R&S FS300, Trace 1 is automatically turned on and
activated. Trace 2 is turned off. All the settings are for Trace 1.
•
In the
submenu,
press the
function key
if Trace 2 is
turned on and active.
Trace 1 becomes the active trace. All the following settings are for this
trace. The current display mode, e.
g. MAX HOLD (MAX, 6-134), is
displayed in the top left of the diagram area in the trace colour:
Turning on
and activating
Trace 2
When the R&S FS300 is turned on, Trace 2 is turned off. When the trace is
called for the first time, the CLEAR/WRITE display mode is set.
•
Press the
f
unction key
in the
submenu.
Trace 2 becomes the active trace. All subsequent settings are for this
trace. In the top left of the diagram area, the current display mode is
shown in the trace colour, e.
g. CLEAR/WRITE (CLR, 6-134):
Summary of Contents for FS300
Page 1: ...2 2006...
Page 16: ......