Preparing for Use
R&S
®
ESW
18
Getting Started 1328.4922.02 ─ 06
► Connect the R&S
ESW to the AC power supply using the supplied power
cable.
Since the instrument is assembled in line with the specifications for safety
class EN61010, it may only be connected to an outlet that has a ground con-
tact.
4.1.5
Switching the Instrument On and Off
Switching the instrument on
► Press the AC power switch on the rear panel to position "I".
The instrument is supplied with AC power. After booting, the instrument is
ready for operation. A green LED above the [POWER] key indicates this.
An orange LED indicates the instrument is in standby mode
Warm-up time for OCXO
When the instrument is switched on, the OCXO requires an extended
warm-up time (see data sheet).
Switching the instrument off
1. Press the [POWER] key on the front panel.
The R&S
ESW switches to standby mode.
2. Set the AC power switch on the rear panel to position "O", or disconnect the
instrument from the AC power supply.
The R&S
ESW changes into off mode.
Putting into Operation