R&S esu, Quick Start Manual

Page: 59 / 223

Quick Start Guide 1302.6163.62 - 04 2.9
R&S ESU Preparing for Use
Connecting External Devices
2.3 Connecting External Devices
2.3.1 Connecting an External Keyboard
An external PC keyboard can be connected to the USB interface on the front or the rear panel
of the R&S ESU.
The keyboard simplifies instrument operation and the entry of comments, file names, etc.
Keyboards and mouse devices conform to USB Standards 1.1 or 2.0 are suitable for
connection to the USB interface.
After being connected, the keyboard is automatically detected. The default keyboard language
setting is US English. Special settings such as refresh rate, etc. can be made in the
Windows XP Start menu by selecting
START - SETTINGS - CONTROL PANEL -
KEYBOARD .
International Keyboard Support
As of firmware version 4.3x, the following international keyboard drivers are supported.
• French Keyboards
• German Keyboards
• Italian Keyboards
• Portuguese Keyboards
• Spanish Keyboards
These drivers are already installed on the R&S ESU, if it is shipped with firmware version 4.3x
or later. A separate installer file is available on the
R&S ESU internet site .
To change the keyboard driver language proceed as follows:
1. Start Windows Explorer
2. Start the installation procedure with double click onto the file
FsxInternationalKey-
boards.msi .
3. Reboot the analyzer.
4. Now open the windows start menu by pressing the windows key or
<CTRL> <ESC> .
Do not connect the keyboard unless the instrument is switched off (STANDBY). Otherwise,
proper functioning cannot be ensured due to interactions with the firmware.
USB