R&S ESU
Preparing for Use
Preparing for Operation
2.4
Quick Start Guide 1302.6163.62 - 04
2.1 Preparing for Operation
This section describes how to put the instrument into operation.
2.1.1 Unpacking the Instrument
➢
Remove the instrument from its packaging and check the equipment for completeness
using the delivery note and the accessory lists for the various items.
➢
First, pull off the polyethylene protection pads from the instrument's rear feet and then
carefully remove the pads from the instrument handles at the front.
➢
Pull off the corrugated cardboard cover that protects the rear of the instrument.
➢
Carefully unthread the corrugated cardboard cover at the front that protects the instrument
handles and remove it.
➢
Check the instrument for any damage. If there is damage, immediately contact the carrier
who delivered the instrument. In this case, make sure not to discard the box and packing
material.
It is advisable to keep the original packing material in order to prevent control elements and
connectors from being damaged in case the instrument is to be transported or shipped at a
later date.
Protective plastic caps for the front panel and the rear panel can be ordered addditionally
(order number 1096.7095.00). Please note that you need to order 2 covers for 1 instrument.
2.1.2 Setting Up the Instrument
The instrument is intended for indoor use. Note the following in this regard:
• The ambient temperature must comply with the range specified in the data sheet.
• Air inflow and outflow via the air vents on the rear panel and through the lateral perforations
must not be obstructed. Clearance from walls must be at least 10 cm.
• The mounting surface must be even.
Before putting the instrument into operation, make sure that the following requirements
have been met:
• The air vents are not blocked.
• No signal voltage levels exceeding the permitted limits are present at the inputs.
• The instrument's outputs are neither overloaded nor incorrectly connected.
Not complying with these requirements can result in damage to the instrument.
Summary of Contents for esu
