R&S esu, Quick Start Manual

Page: 140 / 223

R&S ESU Basic Measurement Examples
Storing and Loading Instrument Settings
5.36 Quick Start Guide 1302.6163.62 - 04
2. By selecting the data record from a list:
➢
Press the FILE key and then the RECALL softkey.
➢
Press the ITEMS TO SAVE/RCL softkey.
The list of available data records is shown.
➢
Select the data record to be loaded by using the rotary knob and confirm by pressing
ENTER twice. The data record will be loaded.
➢
To change the instrument configuration path, use the EDIT PATH softkey.
5.7.2.1 Automatic Loading of a Data Record during Booting
If the R&S ESU is switched on in the factory default state, it loads the instrument settings that
it had when switched off (provided that it was switched off using the
STANDBY switch on the
front panel; see chapter “ Switching Off the R&S ESU” on page 2.7 ).
However, the R&S ESU can also automatically load a data record defined by the user. This
requires performing the following procedure:
➢
Press the FILE key and then the RECALL softkey.
➢
Press the STARTUP RECALL softkey.
The list of available data records is shown.
To load stored traces, use the ITEMS TO SAVE/RCL softkey to select
the All Traces field.
During loading, the R&S ESU detects which parts the called data
record contains and, if applicable, ignores any partial data records that
were selected but are not available.