Remote Control
R&S
®
ESR
654
User Manual 1175.7068.02 ─ 12
<m>
1...16
Selects the marker.
Parameters:
<Frame> | <Time>
<Frame> (if time stamp is off)
Defines the frame to place the marker on. The range is {0...num-
ber of recorded frames-1}
Note that in receiver mode, it is not possible to select a frame,
only a time.
<time> (if time stamp is on)
Defines the distance of the marker in seconds to the last mea-
sured frame (frame 0).
Example:
CALC:MARK:SGR:FRAM -20
Sets the marker on the 20th frame before the present.
CALC:MARK2:SGR:FRAM 2 s
Sets second marker on the frame 2 seconds ago.
CALCulate<n>:MARKer<m>:SGRam:SARea
<SearchArea>
This command defines the marker search area.
The command is available for the spectrogram.
Suffix:
<n>
.
1...4
Selects the measurement window.
<m>
1...16
Selects the marker.
Parameters:
<SearchArea>
VISible
Performs a search in the visible frames.
Note that VISible is ignored if Spectrogram is not visible for any
reason (e.g. if the Spectrum Analyzer is in full screen mode or
display update is inactive).
MEMory
Performs a search over all frames in the memory.
*RST:
VISible
Example:
CALC:DELT:SGR:SAR MEM
Performs a search over all frames in the memory.
Manual operation:
See
CALCulate<n>:MARKer<m>:SGRam:XY:MAXimum[:PEAK]
This command positions the specified marker on the current peak level of the spectro-
gram. The possible position depends on the marker search area.
The command is available for the spectrogram.
Remote Commands in Receiver Mode
