R&S ESR Series, User Manual

Page: 196 / 1126

Receiver Mode
R&S
®
ESR
193 User Manual 1175.7068.02 ─ 12
Remote command:
CALCulate<n>:PEAKsearch|PSEarch:METHod
on page 680
No Of Peaks
Defines the number of peaks the R&S ESR looks for during a peak search.
The range is from 1 to 500 peaks.
The number of peaks only takes effect if the peak search mode is "Peaks".
Remote command:
CALCulate<n>:PEAKsearch|PSEarch:SUBRanges
on page 680
No of Subranges / Peaks per Subrange
Defines the number of subranges for a subrange peak search and the number of
peaks that the R&S
ESR looks for in each subrange.
Note that the maximum number of peaks is 500. Thus, the maximum number of peaks
per subrange depends on the number of subranges you have defined.
These parameters only take effect if the peak search mode is "Subranges".
Remote command:
Number of subranges:
CALCulate<n>:PEAKsearch|PSEarch:SUBRanges
on page 680
Peaks per subrange:
CALCulate<n>:PEAKsearch|PSEarch:SUBRanges:PCOunt
on page 681
Peak Excursion
Defines the relative signal level to determine a peak during a peak search.
For more information see Chapter 5.1.4, "Peak List and Data Reduction" , on page 148.
Remote command:
CALCulate<n>:MARKer<m>:PEXCursion
on page 679
Margin
Defines an additional level margin relative to a limit line that is considered during a
peak search.
For more information see Chapter 5.1.4, "Peak List and Data Reduction" , on page 148.
Remote command:
CALCulate<n>:PEAKsearch|PSEarch:MARGin
on page 680
Select Limit Line
Applies one or more limit lines for the peak search.
For more information on limit lines see Chapter 5.4.3, "(Limit) Lines" , on page 208.
"Assign to
Trace" Assigns the limit line to one or more traces.
"Deselect all
Traces"
"Limitcheck
(On Off)" Turns the limit check on and off.
Common Measurement Settings