Software and Firmware Update
R&S
®
EB500
63
Getting Started 4072.8432.02 ─ 04
Updating the EB500 with front control panel
The EB500 with front control panel can also be updated using the method
with the Update32 tool. Please take note that this method cannot update the
GUI. This might cause version conflicts between receiver firmware and GUI.
For updating the EB500 with front control panel, use the method described in
chapter 4.2, "Receiver Firmware and GUI Update for EB500 with front control
panel"
If the R&S
EB500 cannot reboot
Because the Update32 Tool performs its firmware updates over the LAN,
there could be a conflict if another user is running the tool in the same network.
The R&S
EB500 might "hang" after a reboot because the bootloader gets
"trapped" by this Update32 on the network. In such cases the best advise is:
unplug the network cable during boot-up and find out who else is running
Update32 on the corporate network.
4.4
GUI Installation for Remote Access
This section explains how to install the Remote GUI for use on a notebook or desk-
top PC.
Internal installation
If you want to install the GUI on the R&S
EB500, follow the procedure descri-
bed in
chapter 4.2, "Receiver Firmware and GUI Update for EB500 with front
4.4.1
Preparations
Required files and accessories
The Remote Access GUI can be retrieved from either one of the locations mentioned
at
GUI Installation for Remote Access
