LTE PRACH Measurement
R&S
®
CMW-KM5xx/-KS5xx
812
User Manual 1173.9628.02 ─ 16
<OutOfTolerance>
Out of tolerance result, i.e. percentage of measurement inter-
vals of the statistic count (
) exceeding the specified power dynamics
limits.
Range:
0 % to 100 %
Default unit: %
<OffPowerBefore>
OFF power mean value for subframe before preamble without
transient period
Range:
-100 dBm to 55 dBm
Default unit: dBm
<OnPowerRMS>
ON power mean value over preamble
Range:
-100 dBm to 55 dBm
Default unit: dBm
<OnPowerPeak>
ON power peak value within preamble
Range:
-100 dBm to 55 dBm
Default unit: dBm
<OffPowerAfter>
OFF power mean value for subframe after preamble without
transient period
Range:
-100 dBm to 55 dBm
Default unit: dBm
Example:
See
Performing Single-Shot Measurements
Usage:
Query only
Firmware/Software:
V2.0.10
For additional information concerning syntax elements and returned values refer to
Conventions and General Information
.
4.5.4 Combined Signal Path Commands
For some settings, the command to be used depends on the active scenario. While the
Combined Signal Path (CSP) scenario is active, these settings are configured via com-
mands of the signaling application. While the Standalone (SA) scenario is active, they
are configured via measurement commands.
The following table provides the mapping for PRACH measurement commands. For
general measurement settings, see
Command Reference
深圳德标仪器
135-1095-0799
