LTE Signaling
R&S
®
CMW-KM5xx/-KS5xx
317
User Manual 1173.9628.02 ─ 16
<TX2Connector>
RF1C | RF1O | RF2C | RF3C | RF3O | RF4C | RFAC | RFAO |
RFBC
RF connector for the second output path. Select different con-
nectors for the two paths.
<TX2Converter>
TX1 | TX2 | TX3 | TX4
TX module for the second output path. Select different modules
for the two paths.
<IQ3Connector>
IQ2O | IQ4O | IQ6O | IQ8O
DIG IQ OUT connector for external fading of the third output
path. Select different connectors for the paths.
<IQ4Connector>
IQ2O | IQ4O | IQ6O | IQ8O
DIG IQ OUT connector for external fading of the fourth output
path. Select different connectors for the paths.
Example:
See
Firmware/Software:
V3.2.80
Options:
R&S CMW-KS510, R&S CMW-KS520 and R&S CMW-KS521
Manual operation:
See
ROUTe:LTE:SIGN<i>:SCENario:MTFading:INTernal
<RXConnector>,
<RXConverter>, <TX1Connector>, <TX1Converter>, <TX2Connector>,
<TX2Converter>
Activates the scenario "1 Cell - Fading - MIMO4x2 - 2 RF Out" with internal fading,
using two RF output (TX) paths and one RF input (RX) path. Selects the RF connec-
tors and RX/TX modules.
To query the active scenario, use
.
Depending on the installed hardware and the active sub-instrument or instance <i>
only a subset of the described parameter values is allowed. The *RST values and the
mapping of virtual connector names to physical connectors also depend on the active
sub-instrument or instance <i>.
All instruments are equipped with the RF 1 and RF 2 connectors and one RX and TX
module. Additional RF connectors and RX/TX modules are optional.
See also: "Signal Path Settings" in the R&S
CMW user manual, chapter "Remote Con-
trol"
Connector names:
●
RF1C | RF2C | RF3C | RF4C = RF 1 COM to RF 4 COM, front panel
●
RFAC | RFBC = virtual names for the RF COM connectors
●
RF1O | RF3O = RF 1 OUT | RF 3 OUT, front panel
●
RFAO = virtual name for the RF OUT connectors
Command Reference
深圳德标仪器
135-1095-0799
