1xEV-DO Signaling
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
89
User Manual 1173.9511.02 ─ 11
RMCTAP Configuration > Min / Max Packet Size
The RMCTAP protocol specifies the procedures and messages to control the Reverse
Traffic Channel for subtype 3 signals. The logic is the same as for subtype 2 (see
RETAP Configuration > Min / Max Packet Size
for the relation), but in the multi-carrier
case a different range of possible packet size indices may be defined for each carrier.
Remote command:
2.4.8.5
Session Layer
The following parameters configure the session layer. The settings apply to all network
releases.
The session layer provides address management, protocol negotiation, protocol config-
uration and state maintenance services.
Fig. 2-38: Session layer settings
Inactive Session Timeout
Time after which the AT, if it does not detect any traffic from the R&S
CMW directed to
it, closes the session ("Inactive" state of the Session Management Protocol).
Remote command:
Subnet Included
Specifies whether the "UATISubnetMask" and "UATI104" fields are included in the
UATIAssignment message.
Remote command:
2.4.8.6
Connection Layer
The following parameters configure the connection layer for subtype 0/1 signals. The
settings for subtype 0/1 signals and for subtype 2 signals are identical and overwrite
each other.
The connection layer controls the state of the air-link and prioritizes the traffic that is
sent over it.
GUI Reference
深圳德标仪器
135-1095-0799
