R&S CMW-KG8 Series, User Manual, Page: 789 / 964

CDMA2000 Measurements
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
789 User Manual 1173.9511.02 ─ 11
Manual operation: See "Trigger Delay" on page 752
TRIGger:CDMA:MEAS<i>:MEValuation:MGAP <MinTriggerGap>
Sets a minimum time during which the IF signal must be below the trigger threshold
before the trigger is armed so that an IF power trigger event can be generated.
Parameters:
<MinTriggerGap> Range: 0 s to 0.01 s
*RST: 0 s
Default unit: s
Example: See Configuring the Trigger System
Firmware/Software: V2.0.10
Manual operation: See "Minimum Trigger Gap" on page 752
TRIGger:CDMA:MEAS<i>:MEValuation:EOFFset <EvalOffset>
Defines a delay time for the measurement relative to the "IF Power" or external trigger
events (see
TRIGger:
​
CDMA:
​
MEAS<i>:
​
MEValuation:
​
SOURce
​
). The range is
entered as an integer number of power control groups (PCG). Each PCG has a dura-
tion of 1.25 ms.
Parameters:
<EvalOffset> Range: 0 to 64
*RST: 0
Default unit: power control group
Example: See Configuring the Trigger System
Firmware/Software: V2.0.10
5.5.4 Multi Evaluation Measurement Commands
The commands for the CDMA2000 multi evaluation measurement are divided into the
groups listed below. The general measurement settings also affect the measurement,
see
General Measurement Settings .
● Measurement Control and States ......................................................................... 790
● Enabling Results and Views ..................................................................................792
● Measurement Parameters .....................................................................................795
● List Mode Settings .................................................................................................800
● Limits (Power and Modulation) ..............................................................................805
● Limits (Code Domain) ........................................................................................... 809
● Limits (Spectrum) ..................................................................................................811
● EVM Results (Traces) ...........................................................................................812
● Magnitude Error Results (Traces) .........................................................................813
● Phase Error Results (Traces) ................................................................................813
● IQ Constallation Results (Traces) ......................................................................... 814
● CDP and CDE Results (Traces) ............................................................................814
Command Reference
深圳德标仪器
135-1095-0799