1xEV-DO Signaling
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
57
User Manual 1173.9511.02 ─ 11
ESN
The hard-coded Electronic Serial Number of the connected AT is shown in hexadeci-
mal format.
Remote command:
MEID
Mobile Equipment Identifier, a 56-bit number (14-digit hexadecimal) which allows for a
larger number of ATs to be identified than in the existing ESN numbering system.
Remote command:
Preferred Ctrl Ch Cycle
The control channel cycle in which the AT makes a transition out of the dormant state
in order to monitor the Control Channel.
Remote command:
Preferred Ctrl Ch Enable
Indicates whether or not the AT selects the Preferred Control Channel Cycle. A value
of "0" means that AN and AT both use a common hash function to determine which
Preferred Control Channel Cycle to use. A value of "1" means that the AT tells the AN
which Preferred Control Channel Cycle is used.
Remote command:
Long Code Mask I and Q
The reverse traffic channel in phase and quadrature phase long code masks associ-
ated with the access terminal's session.
Remote command:
AT IPv4 Address, IPv6 Prefix
Display the IPv4 address and/or the IPv6 prefix that have been assigned to the AT by
the R&S
CMW. The AT indicates whether it supports IPv4 only or IPv6 only or both.
Depending on this information the R&S
CMW assigns either an IPv4 address or an
IPv6 prefix or both and displays the assigned values.
Remote command:
2.4.1.3
Access Network Control
The main view provides only the most important settings for fast access.
GUI Reference
135-1095-0799