CDMA2000 Signaling
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
495
User Manual 1173.9511.02 ─ 11
3. Establish a call. Afterwards click the softkey "Send SMS".
Since a call is already connected the R&S
CMW sends the message over the Traf-
fic Channel.
Depending on the selected outgoing SMS message settings the message is truncated
or multiple files are sent. If requested by the R&S
CMW the MS sends an acknowledg-
ment back after receiving the message successfully. Also if an error occurs the MS
sends an
SMS_Cause_Code
back to the R&S
CMW. After sending the message the
R&S
CMW updates the entries at "MS Info > Messaging (SMS) Info > Last Sent Mes-
sage" display.
4.2.14.3
SMS_Cause_Code
The parameter CAUSE_CODE provides the delivery status of the message user data.
Refer to 3GPP2 C.S0015-A and N.S0005.
Table 4-13: Network Problems
Text
Description
Address vacant
SMS Destination Address is valid but not currently allocated to
an SMS terminal. The MIN associated with a valid destination
address is not known to its HLR.
Address translation failure
The SMS Destination Address is invalid (e.g., address is not a
recognized address type, address is not for a known or possi-
ble SMS functional entity, the MIN associated with a destina-
tion MS address does not correspond to its HLR, the ESN
associated with a destination MS does not match the expected
value, the SMS_DestinationAddress, SMS_OriginalDestinatio-
nAddress, destination MIN, or original destination subaddress
does not match the address of a destination SME, etc.).
Network resource shortage
Network transmission failed due to lack of a network resource
or link capacity
Network failure
A network node failed, a link failed or a required operation
failed.
Invalid Teleservice ID
The SMS_TeleserviceIdentifier is not known, is not supported
or is not authorized by an addressed functional entity.
Other network problem
A network problem other than identified above.
Table 4-14: Terminal Problems
Text
Description
No page response
The addressed MS-based SME is known, but it does not
respond to a page. SMS Notification is not pending.
Destination busy
The destination MS-based SME is SMS capable, but is cur-
rently engaged in a call, a service or a call mode that pre-
cludes the use of SMS or the destination SME is congested.
This value shall only be used between the MSC and the MC
when allowed by bilateral agreement. SMS Notification is not
pending.
General Description
深圳德标仪器
135-1095-0799