1xEV-DO Signaling
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
102
User Manual 1173.9511.02 ─ 11
Preamble Length
Length in frames of the access probe preamble (PreambleLength).
Setting this parameter requires option R&S CMW-KS890.
Remote command:
Access Cycle Duration
Length in slots of the access cycle. When using the Default Access Channel Protocol,
an AT may start to transmit an access probe only at the beginning of an access cycle.
With the Enhanced Access Channel Protocol (network revision A), an AT may start to
transmit an access probe only Access Offset slots after the beginning of an access
cycle.
Setting this parameter requires option R&S CMW-KS890.
Remote command:
Preamble Length Slots
Length in slots of the access probe preamble. With the Enhanced Access Channel
Protocol, the AT uses this value and ignores the value given by the "Preamble Length"
setting. This setting is only applicable when the Enhanced Access Channel Protocol is
used (revision A).
Setting this parameter requires option R&S CMW-KS890.
Remote command:
Sector Access Max. Rate
The Sector Access Max. Rate specifies the maximum rate at which the AT may trans-
mit on the access channel. This setting is only applicable when the Enhanced Access
Channel Protocol is used (revision A).
Setting this parameter requires option R&S CMW-KS890.
Remote command:
2.4.9.5
Security Settings
This section allows to specify the parameters required for EAP-AKA' access authenti-
cation that is required for EMPA and MMPA, see also
chapter 2.2.3.2, "Packet Applica-
Make sure the "Secret Key", "Operator Variant Key" and "Authentication Management
Field" have the same value as in the AT
GUI Reference
深圳德标仪器
135-1095-0799
