WCDMA Signaling
R&S
®
CMW-KG4xx/-KM4xx/-KS4xx
329
User Manual 1173.9657.02 ─ 11
Example:
See
Firmware/Software:
V2.0.10
Manual operation:
See
ROUTe:WCDMa:SIGN<i>:SCENario:DCARrier
<RXConnector>, <RXConverter>,
<TXConnector>, <TXConverter>, <TX2Connector>, <TX2Converter>
Activates the scenario "Dual Carrier", using two RF output (TX) paths and one RF input
(RX) path. Selects the RF connectors and RX/TX modules to be used. To query the
active scenario, use
Depending on the installed hardware and the active sub-instrument or instance <i>
only a subset of the described parameter values is allowed. The *RST values and the
mapping of virtual connector names to physical connectors also depend on the active
sub-instrument or instance <i>.
All instruments are equipped with the RF 1 and RF 2 connectors and one RX and TX
module. Additional RF connectors and RX/TX modules are optional.
See also: "Signal Path Settings" in the R&S
CMW user manual, chapter "Remote Con-
trol"
Connector names:
●
RF1C | RF2C | RF3C | RF4C = RF 1 COM to RF 4 COM, front panel
●
RFAC | RFBC = virtual names for the RF COM connectors
●
RF1O | RF3O = RF 1 OUT | RF 3 OUT, front panel
●
RFAO = virtual name for the RF OUT connectors
Parameters:
<RXConnector>
RF1C | RF2C | RF3C | RF4C | RFAC | RFBC
RF connector for the input path
<RXConverter>
RX1 | RX2 | RX3 | RX4
RX module for the input path
<TXConnector>
RF1C | RF1O | RF2C | RF3C | RF3O | RF4C | RFAC | RFAO |
RFBC
RF connector for the first output path
<TXConverter>
TX1 | TX2 | TX3 | TX4
TX module for the first output path. Select different modules for
the two paths.
<TX2Connector>
RF1C | RF1O | RF2C | RF3C | RF3O | RF4C | RFAC | RFAO |
RFBC
RF connector for the second output path
<TX2Converter>
TX1 | TX2 | TX3 | TX4
TX module for the second output path. Select different modules
for the two paths.
Command Reference
深圳德标仪器
135-1095-0799