R&S AREG800A, User Manual

Page: 309 / 411

Remote control commands
R&S
®
AREG800A
309 User Manual 1179.3615.02 ─ 01
Parameters:
<ZynqNetStatus> 1 | ON | 0 | OFF
*RST:
n.a. (no preset. default: 0)
Example: See Example "Configuring the system control network interface"
on page 308.
Manual operation: See "Network Status" on page 114
:SYSTem:COMMunicate:SYST:NETWork:RESTart
Restarts the network.
Example: See Example "Configuring the system control network interface"
on page 308.
Usage: Event
Manual operation: See "Restart Network" on page 115
:SYSTem:COMMunicate:SYST:NETWork[:COMMon]:HOSTname <ZynqHostname>
Queries the hostname of the instrument connected to the R&S AREG800A via the sys-
tem control interface.
Parameters:
<ZynqHostname> string
Example: See Example "Configuring the system control network interface"
on page 308.
Manual operation: See "Hostname" on page 115
:SYSTem:COMMunicate:SYST:NETWork:IPADdress
Sets the IP address.
Example: See Example "Configuring the system control network interface"
on page 308.
Manual operation: See "IP Address" on page 115
:SYSTem:COMMunicate:SYST:NETWork:IPADdress:MODE <ZynqMode>
Selects manual or automatic setting of the IP address.
Parameters:
<ZynqMode> AUTO | STATic
*RST:
n.a. (factory preset: AUTO)
Example: See Example "Configuring the system control network interface"
on page 308.
Manual operation: See "Address Mode" on page 115
SYSTem:COMMunicate:SYST subsystem