GUI reference
R&S
®
ZNA
598
User Manual 1178.6462.02 ─ 20
5.12.1.1
Controls on the Channels tab
The buttons in the "Channels" tab open the following dialogs:
●
"Channel Manager...": see
Chapter 5.12.1.2, "Channel Manager dialog"
●
"RFFE...": see
Chapter 5.12.1.3, "RFFE Config dialog for R&S
Active Channel
Selects an arbitrary channel of the active recall set as the active channel. This function
is disabled if the current recall set contains only one channel.
If one or several traces are assigned to the selected channel, one of these traces
becomes the active trace.
The order of all channels in a recall set is given by the channels' creation time. By
default, the channels are named Ch1, Ch2, ... so that Ch<n – 1> precedes Ch<n>. This
order is always maintained, even if channels are renamed, invisible (because no traces
are assigned to them) or distributed over several diagram areas.
Tip:
You can also select a line in the channel list to activate the corresponding channel.
Remote command:
The numeric suffix <Ch> appended to the first-level mnemonic of a command selects a
channel as the active channel.
New Channel
Creates a channel and a trace with default settings, and assigns the new trace to the
active diagram area.
Channel Config softtool
