R&S 1332.4500K22, User Manual

Page: 502 / 1709

GUI reference
R&S
®
ZNA
502 User Manual 1178.6462.02 ─ 20
Example:
The segmented sweep range
is described by the following sweep segment file:
Note: The
*.SegList
file actually contains more columns listing all channel settings
of the individual sweep segments. The headings of the additional columns are IF Band-
width [Hz] , en:IF Selectivity , en:IF Sideband , Meas Delay [µs] , bo:Sweep Time
Auto , en:Frq Sweep Mode .
Remote command:
MMEMory:LOAD:SEGMent
MMEMory:STORe:SEGMent
Displayed Columns dialog
The "Displayed Columns" dialog allows you to select the channel settings that can be
defined per sweep segment. These settings are displayed in the
Define Segments dia-
log and in the "Point List" (opened via Show Point List... ).
Access: Define Segments dialog > "Displayed Columns..."
All segment-specific settings can be modified in the "Define Segments" dialog. By
default, the first sweep segment is created with the channel settings defined for unseg-
mented sweep types. When any further sweep segment created, it uses the channel
settings of the previously active segment.
Related information
Refer to the following sections:
●
Chapter 5.10.2.2, "Define Segments dialog" , on page 499
●
"Show Point List..." on page 501
Sweep Softtool