R&S 1332.4500K22, User Manual

Page: 473 / 1709

GUI reference
R&S
®
ZNA
473 User Manual 1178.6462.02 ─ 20
Remote command:
CALCulate:MARKer:COUPled:TYPE
Reset Marker Coupling
Convenience function for disabling marker coupling and setting the Coupling Type to
"All" (default).
Remote command:
CALCulate:MARKer:COUPled[:STATe] OFF
CALCulate:MARKer:COUPled:TYPE ALL
5.8 Stimulus softtool
On the "Stimulus" softtool, you can access to the stimulus parameters of the active
channel. If the active trace is represented in
Time Domain , it also allows you to config-
ure the "observation interval".
Access: Stimulus – [Start] | [Stop] | [Center] | [Span] key
●
While in Cartesian diagrams the x-axis represents the stimulus values, in polar and
Smith diagrams this direct relation is lost. In any case, a marker can be used to dis-
play the stimulus value of a given trace point.
For "Time Domain" traces, points in the "observation interval" are interpreted as
stimulus values.
●
All stimulus settings except the "Time Domain X-Axis" settings are channel set-
tings. "Time Domain X-Axis" applies to the active (time domain) trace only.
Background information
Refer to the following sections:
●
Chapter 4.1.3, "Traces, channels and diagrams" , on page 85
●
Chapter 3.3.7.2, "Setting the sweep range" , on page 72
●
Chapter 3.3.7.6, "Set by marker" , on page 73
5.8.1 Stimulus tab
Defines the sweep range in the current channel, depending on the sweep type.
Related Settings
Refer to the following sections:
●
Chapter 4.1.4.3, "Stimulus and sweep types" , on page 90
●
Chapter 5.10.2, "Sweep Type tab" , on page 491
Stimulus softtool