R&S 1332.4500K22, User Manual

Page: 1525 / 1709

Command reference
R&S
®
ZNA
1525 User Manual 1178.6462.02 ─ 20
TRIGger[:SEQuence]:LTRigger:RESet
Clears the lost trigger event log.
Usage: Event
Manual operation: See "Clear Lost Trigger Log" on page 809
TRIGger<Ch>[:SEQuence]:MULTiple:HOLDoff <MeasSequence>[, <DelayTime>]
Sets a delay time between the trigger event and the start of the measurement ("Trigger
Delay") in multiple trigger mode.
Suffix:
<Ch>
.
Channel number
Parameters:
<MeasSequence> SWEep | SEGMent | POINt | PPOint
Triggered measurement sequence,
PPOint
denotes "partial
measurement"; see
TRIGger<Ch>[:SEQuence]:LINK
.
<DelayTime> Delay time
Range:
0 s to 13680 s
Increment: 10 ms
*RST:
0 s
Default unit: s
Example: See
TRIGger<Ch>[:SEQuence]:MULTiple:SOURce<inp>
Manual operation: See "... /Logic/ ..." on page 509
TRIGger<Ch>[:SEQuence]:MULTiple:LOGic <Sequence>[, <TrigLogic>]
Defines the logical combination of the trigger events defined in
TRIGger<Ch>[:
SEQuence]:MULTiple:SOURce<inp>
that will trigger measurement sequence
<Sequence>.
Suffix:
<Ch>
.
Channel number
Parameters:
<Sequence> SWEep | SEGMent | POINt | PPOint
Triggered measurement sequence
PPOint
denotes "partial measurement"; see
TRIGger<Ch>[:
SEQuence]:LINK
.
<TrigLogic> NONE | AND | OR
NONE
only trigger event 1 is considered
AND
logical AND of trigger events 1 and 2
SCPI command reference