R&S 1332.4500K22, User Manual

Page: 1471 / 1709

Command reference
R&S
®
ZNA
1471 User Manual 1178.6462.02 ─ 20
Example: See
SOURce<Ch>:POWer<PhyPt>[:LEVel][:IMMediate]:
LLIMit:VALue
on page 1472
Manual operation: See "Port Power Limits" on page 799
SOURce<Ch>:POWer<PhyPt>:GENerator<Gen>:LLIMit:VALue <arg0>
Defines a limit for the source power of an external generator no.
<Gen>
. The limit must
be enabled explicitly using
SOURce<Ch>:POWer<PhyPt>:GENerator<Gen>:LLIMit[:STATe]
.
Suffix:
<Ch>
.
Channel number. This suffix is ignored; the limit applies to all
channels.
<PhyPt> Test port number of the analyzer. This suffix is ignored; the gen-
erator is selected via
<Gen>
.
<Gen> Generator number
Parameters:
<arg0> Limit for the generator power.
Range:
Depending on the generator model.
Increment: 0.1-dB
*RST:
The power limit is not changed after a *RST. The
factory setting is 0 dBm.
Default unit: dBm
Example: See
SOURce<Ch>:POWer<PhyPt>[:LEVel][:IMMediate]:
LLIMit:VALue
on page 1472
Manual operation: See "Port Power Limits" on page 799
SOURce<Ch>:POWer<PhyPt>[:LEVel][:IMMediate]:LLIMit[:STATe] <arg0>
Enables or disables the limit for the source power at port no.
<PhyPt>
. The limit is
defined using
SOURce<Ch>:POWer<PhyPt>[:LEVel][:IMMediate]:LLIMit:VALue
.
Suffix:
<Ch>
.
Channel number. This suffix is ignored; the setting applies to all
channels.
<PhyPt> Test port number of the analyzer.
Parameters:
<arg0> ON | OFF: Enable or disable the power limit.
*RST:
The power limit settings are not changed after a
*RST. The factory setting is OFF.
Example: See
SOURce<Ch>:POWer<PhyPt>[:LEVel][:IMMediate]:
LLIMit:VALue
on page 1472
Manual operation: See "Port Power Limits" on page 799
SCPI command reference