Command reference
R&S
®
ZNA
1021
User Manual 1178.6462.02 ─ 20
h<order>b<recPort>(p<drvPort>)[Relative]
of order <order>
Harmonic measurement with:
●
Order <order>
●
Drive port <drvPort>
●
Receive port <recPort>
●
R
elative or direct
Cu(P<Src Port>)<_lowercase_ext_dll_name>/<Task
Type>/<Additional Input>
Traces calculated using
<ext_dll_name>.dll
.
*) Selecting a parameter Y...<n><m> or Z...<n><m> sets the range of port numbers to
be considered for the Y and Z-parameter measurement to <n>:<m>.
CALCulate<Ch>:PARameter:SDEFine:SENDed
<TraceName>, <Result>
Creates a trace and assigns a channel number, a name and a measurement parame-
ter to it. The trace becomes the active trace in the channel but is not displayed.
Similar to
CALCulate<Ch>:PARameter:SDEFine
, but in presence of balanced ports
this command distinguishes between
●
single-ended S-parameters for
logical
ports (
SSS<Li><Lj>
)
●
"raw" single-ended S-parameters referring to
physical
ports (
S<Pi><Pj>
)
Suffix:
<Ch>
.
Channel number
Setting parameters:
<TraceName>
Trace name
<Result>
Measured quantity
Usage:
Setting only
Manual operation:
See
CALCulate<Ch>:PARameter:SELect
<TraceName>
Selects an existing trace as the active trace of the channel. All trace commands with-
out explicit reference to the trace name act on the active trace (e.g.
).
CALCulate<Ch>:PARameter:SELect
is also neces-
sary if the active trace of a channel has been deleted.
Suffix:
<Ch>
.
Channel number.
Parameters:
<TraceName>
Trace name, e.g. 'Trc4'. See "Rules for trace names" in
SCPI command reference
