R&S 1322.8003K06, User Manual

Page: 96 / 555

Measurements and Result Displays
R&S
®
FSPN
96 User Manual 1179.4363.02 ─ 01
Remote command:
Trace data:
TRACe<n>[:DATA]?
on page 333
Y-axis scale: Chapter 11.6.9.1, "Frequency Configuration" , on page 386
Frequency Deviation
The "Frequency Deviation" result display shows the frequency deviation of the transi-
ent response of the DUT from an ideal linear behavior over time.
The x-axis shows the time period over which the signal has been measured. The scale
depends on the defined start and stop time.
The y-axis shows the deviation of the signal from the reference line within the time-
frame between start and stop time. The scale of the y-axis depends on your configura-
tion.
The frequency deviation calculation settings are described in Chapter 6.9.7, "Fre-
quency Deviation" , on page 140.
Remote command:
Trace data:
TRACe<n>[:DATA]?
on page 333
Phase
The "Phase" result display shows the phase characteristics of the transient response of
the DUT over time.
The x-axis shows the time period over which the signal has been measured. The scale
depends on the measurement time.
The y-axis shows the phase. The scale of the y-axis depends on your configuration.
Remote command:
Trace data:
TRACe<n>[:DATA]?
on page 333
Y-axis scale: Chapter 11.6.9.5, "Y-Axis Scale" , on page 394
Marker Table
Displays a table with the current marker values for the active markers.
This table is displayed automatically if configured accordingly.
Remote command:
LAY:ADD? '1',RIGH, MTAB
, see
LAYout:ADD[:WINDow]?
on page 404
Results:
CALCulate<n>:MARKer<m>:X
on page 430
Result Displays