Tap the
Timers
tab to view timers,
odometer readings, and times.
Tap the
Logs
tab to view a list of states.
Tap on a state to view individual logs.
Enter truck information and access truck-specific use tools
Show location on the map and view navigation instructions
Change driver status
Choose a destination
Select TND and route preferences
Mute the speaker
Adjust speaker volume
GPS Signal Indicator
To Power the Device:
On
Press and hold the Power Key for two seconds.
(Device powers on in five seconds.)
Off
Press and hold the Power Key for five seconds.
To Enter or Return from Standby Mode:
Press and release the Power Key.
Overview
See safety information included with the device for
warnings and precautions.
NOTE:
To maximize battery life, plug in and charge the
navigation unit for the first two hours of use.
Install the Mount
Note:
Follow all local regulations governing the placement of
the mount.
Select an area with a line of sight to the sky and GPS satellites
to ensure reliable GPS information.
Clean and dry the mounting area.
Remove the suction cup protective film.
Adjust the angle of the mount using the thumbscrew and
slide the mount into the cradle.
Pull the suction cup lever up to release suction.
Place and hold the mount suction cup against the
mounting surface.
Press the suction cup lever down until it snaps into place.
Angle the bottom of the TND device into the cradle and
align the two slots on the bottom of the device into the
two ridges on the cradle.
Press the top of the device toward the cradle until you
hear the upper clip latch into place.
Enter Truck Information
Tap
Truck Tools
>
Truck Info
.
Tap and to view all options.
Tap the option button to be changed.
Enter new truck information settings.
Tap
Back
to save changes.
View Timers and Logs
Countdown timers are controlled by the Driver Status (
Driving
,
On Duty
, or
Off Duty)
selected on the Main Menu.
Tap
Truck Tools
>
Timers and Logs
Plug the power cord into the device and the vehicle’s
12-volt power source.
Adjust the navigation device so that it can be easily seen
and does not block the driver’s line of sight.
Main Menu
TND
TM
700
Redefining Truck Navigation
Quick Start Guide
1
1
1
1
1
3
3
3
3
3
4
4
4
4
4
5
5
5
5
6
7
8
6
7
8
9
10
6
7
8
2
2
2
2
2
NOTE:
Use the
Reset button
(located on the
back of the device)
to restore factory
settings and restart
the device.
Power Key
Battery Power Indicator
Bright Red:
Device is plugged
in and the battery is charging.
Bright Green:
Device is
plugged in and the battery
is fully charged.
Light Green:
Device is
in Standby Mode.
Note:
Do not place
the mount in an airbag
deployment area.
On the left,
tap on an
option
On the right,
enter settings
for the option
