Rami - TEL 300/TEL 300S
15
ENGLISH
[
Connect the TEL 300 according to the wiring given (Wiring 1 or 2 depending on
configuration).
[
Call your first correspondent using the telephone (switch
10
on standby).
[
Take the line using switch
10
.
[
Adjustment of the line (this operation is carried out only once as it allows the insert to be
adapted to your local switchboard (the adjustment can be checked from time to time). This
procedure consists of eliminating, as much of the signal sent to the correspondent as
possible from the correspondent's return.
[
Put volume
7
« send modulation » to zero.
[
Press down switch
9
« test generator » (the signal is calibrated and independent of volume
7
SEND MOD.).
[
Vu-meter
14
shows a level 0dB.
[
Adjust volume
8
«return correspondent» so as to attain a O dB level on vu-meter
13
.
[
Adjust in alternation the line adjustment potentiometers
11
and
12
so as to obtain the lowest
level possible on vu-meter
13
. One can then alter volume 8 to increase the sensitivity and
readjust the potentiometers
11
and
12
(It must be noted that the potentiometers
11
and
12
have a position of balance and that they are interactive); once the optimum adjustment is
reached release the « test generator » (switch
9
).
[
The
TEL 300
insert is now adapted to your line and is fully functional.
USE
[
To switch the correspondent over to monitor, it is first necessary to send a signal from the
console to the correspondent; adjust volume
7
« send modulation » using vu-meter
14
and
adjust volume
8
« return correspondent » using the vu-meter
13
.
[
It is possible to send instructions to the correspondent using mic input or line mono and
volume
7
« send modulation to the correspondent ».
[
Monitoring only the correspondent is possible using C output. (Control for the studio).
[
Monitoring the correspondent and sending is possible using the
D
output (recording).
[
Lighting up of switch
10
signals an incoming call.
[
Input
B
receives console output (send console Compact or RP2000).
[
The
C
output goes to the operation.
OPTION : (TEL 300S) AUTOMATIC LINE PICK UP
When being used at a distance, for example, the
TEL300S
can take a call automatically as soon
as it comes in and then hang up at the end of the call.
Switch
10
must be in release position so as to allow the automatic mode to function; only in this
case will the TEL 300S take the call after 4 rings.
Hanging up after the call can done in several ways:
[
In normal use, the
TEL 300S
will let the hang up tone ring 9 times before actually hanging up.
[
Where one would like to avoid this tone being heard it is possible to control the hanging up
from a distance by pressing keys « * » then « 0 » in that order.
[
By pressing switch
10
an operator can at any time take back control of the
TEL 300S
thus
returning it to normal mode; the release position of this key will force the hanging up of the
TEL300S
.optimum.
IMPLEMENTATION
