RAM Truck 2013, Owner'S Manual

Page: 41 / 183

CAUTION!
The engine may automatically crank when the ‘‘Wait
To Start’’ time has elapsed. To abort the automatic
starting process, ensure the driver’s foot is fully
removed from the brake pedal prior to pushing the
START/STOP button to cycle the ignition off.
5. After engine start-up, check to see that there is oil
pressure.
6. Allow the engine to idle about three minutes until the
manifold heaters have completed the post-heat cycle.
7. Release the parking brake and drive.
NOTE:
•
Engine idle speed will automatically increase to
1,000 RPM and engage the Variable Geometry Turbo-
charger at low coolant temperatures to improve engine
warm-up.
•
If the engine stalls, or if the ignition switch is left ON
for more than two minutes after the “Wait To Start
Light” goes out, reset the grid heaters by turning the
ignition switch to the OFF position for at least five
seconds and then back ON. Repeat steps 1 through 7 of
“Keyless Enter-N-Go Starting Procedure – Engine
Manifold Air Temperature Below 66° F (19° C).”
4
STARTING AND OPERATING 39