GEAR SELECTOR OVERRIDE
If a malfunction occurs and the gear selector cannot be moved out of the PARK
position, you can use the following procedure to temporarily move the gear selector:
1. Turn the engine OFF.
2. Firmly apply the parking brake.
3. Using a screwdriver or similar tool, carefully separate the gear selector boot from
the center console.
4. Push and maintain firm pressure on
the brake pedal.
5. Insert a small screwdriver or a similar
tool into the gear selector override access hole (at the right front corner of the gear
selector assembly) then push and hold the override release lever down. While still
holding down the override release lever, move the gear selector to the NEUTRAL
position (the shift knob button must be pushed normally to move the lever).
6. The vehicle may then be started in
NEUTRAL.
7. Reinstall the gear selector boot.
Gear selector Boot Location
Gear Selector Override Access Hole
W H A T T O D O I N E M E R G E N C I E S
99
Summary of Contents for PROMASTER CITY
Page 129: ...NOTES 127...
Page 130: ...NOTES 128...
