Driver Memory Seat — If Equipped
This feature allows the driver to store up to two different memory profiles for easy
recall through a memory switch. Each memory profile contains desired position
settings for the driver seat, side mirrors, adjustable pedals (if equipped) and a set of
desired radio station presets. Your Remote Keyless Entry (RKE) Key Fob can also be
programmed to recall the same positions when the UNLOCK button is pushed.
NOTE:
Your vehicle is equipped with two RKE Key Fobs, one RKE Key Fob can be linked to
memory position 1 and the other Key Fob can be linked to memory position 2.
The memory seat buttons are located on the outboard side of the drivers seat cushion.
Programming The Memory Feature
To create a new memory profile, perform
the following:
1. Cycle the vehicles ignition to the ON/
RUN position (do not start the en-
gine).
2. Adjust all memory profile settings to
desired preferences (seat, side mir-
rors, adjustable pedals and radio sta-
tion presets).
3. Push and release the S (Set) button
on the memory switch.
4. Within five seconds, push and release
either of the memory buttons (1) or
(2). The Electronic Vehicle Information Center (EVIC) or Driver Information
Display (DID) will display which memory position has been set.
NOTE:
• Memory profiles can be set without the vehicle in PARK, but the vehicle must be
in PARK to recall a memory profile.
• To set a memory profile to your RKE Key Fob, refer to “Linking And Unlinking The
Remote Keyless Entry Key Fob To Memory” in this section.
Memory Seat Button Location
G E T T I N G S T A R T E D
32
Summary of Contents for Chassis CAB 4500 2016
Page 226: ...NOTES 224...
