RAM CHASSIS CAB 3500 2017, User Manual

Page: 66 / 276

Easy Entry/Exit Seat
This feature provides automatic driver’s seat positioning to enhance driver mobility
when entering and exiting the vehicle.
The distance the driver’s seat moves depends on where you have the driver’s seat
positioned when you remove the key fob from the ignition (or change the ignition to
OFF, for vehicles equipped with Keyless Enter-N-Go).
• When you remove the key fob from the ignition (or change the ignition to OFF, for
vehicles equipped with Keyless Enter-N-Go), the driver’s seat will move about
2.4 inches (60 mm) rearward if the driver’s seat position is greater than or equal
to 2.7 inches (67.7 mm) forward of the rear stop. The seat will return to its
previously set position when you place the ignition into the ACC or RUN position.
• When you remove the key fob from the ignition (or change the ignition to OFF, for
vehicles equipped with Keyless Enter-N-Go), the driver’s seat will move to a
position 0.3 inches (7.7 mm) forward of the rear stop if the driver’s seat position
is between 0.9 inches and 2.7 inches (22.7 mm and 67.7 mm) forward of the rear
stop. The seat will return to its previously set position when you place the ignition
to the ACC or RUN position.
• The Easy Entry/Easy Exit feature is disabled when the driver’s seat position is less
than 0.9 inches (22.7 mm) forward of the rear stop. At this position, there is no
benefit to the driver by moving the seat for Easy Exit or Easy Entry.
Each stored memory setting will have an associated Easy Entry and Easy Exit
position.
NOTE:
The Easy Entry/Exit feature is not enabled when the vehicle is delivered from the
factory. The Easy Entry/Exit feature is enabled (or later disabled) through the
programmable features in the Uconnect system. Refer to “Uconnect Settings/
Customer Programmable Features” in “Understanding Your Instrument Panel” in the
Owner’s Manual on http://www.ramtrucks.com/en/owners/manuals for further infor-
mation.
G E T T I N G S T A R T E D
64