GETTING TO KNOW YOUR VEHICLE
69
Sunroof Maintenance
Use only a non-abrasive cleaner and a soft cloth
to clean the glass panel.
Ignition Off Operation
The power sunroof switch will remain active for
up to approximately 10 minutes after the ignition
switch is turned to the OFF/LOCK position.
Opening either front door will cancel this feature.
NOTE:
Ignition Off time is programmable through the
Uconnect System. Refer to “Uconnect Settings”
in “Multimedia” for further information.
Relearn Procedure
For vehicles equipped with a sunroof, there is a
relearn procedure that allows you to calibrate
the sunroof when the “Express Operation”
feature stops working. To reset the sunroof,
follow these steps:
1. Set the ignition to the ACC or the ON/RUN
position.
2. Ensure that the sunroof is in the fully closed
position.
3. Push and hold the close switch. The sunroof
will hit the hard stop and move to the vent
position after ten seconds.
4. Release the close switch.
5. Push and hold the close switch again within
five seconds to begin the teaching process.
The sunroof will complete one full cycle and
return to the fully closed position.
NOTE:
If the close switch is released anytime during
the teach cycle, the procedure will need to be
repeated starting from the first step.
6. Once the sunroof has stopped in the fully
closed position, release the close switch.
The sunroof is now reset and ready to use.
HOOD
To Open The Hood
To open the hood, two latches must be
released.
1. Pull the hood release lever located below
the steering wheel at the base of the
instrument panel.
Hood Release
2
19_DJD2_OM_EN_USC_t.book Page 69
