190
STARTING AND OPERATING
PARKVIEW REAR BACK UP CAMERA
The ParkView Rear Back Up Camera allows you to see an
on-screen image of the rear surroundings of your vehicle
whenever the gear selector is put into REVERSE. The
image will be displayed on the Uconnect display along with
a caution note to “Check Entire Surroundings” across the
top of the screen. After five seconds this note will
disappear. The ParkView Camera is located in the center
of the tailgate handle.
NOTE:
Removing the tailgate will disable the Rear View Camera
function.
Manual Activation Of The
Rear View Camera
1. Press the Vehicle button located on the bottom of
the Uconnect display and then select the Controls
menu.
2. Press the Back Up Camera icon to turn the Rear View
Camera system on.
When the vehicle is shifted out of REVERSE with Camera
delay turned off, the rear Camera mode is exited and the
previous screen appears again.
When the vehicle is shifted out of REVERSE with Camera
delay turned on, the rear Camera image will be displayed
for up to 10 seconds after shifting to another gear, unless
the vehicle speed exceeds 8 mph (13 km/h), the
transmission is shifted into PARK, the ignition is placed in
the OFF position, or the touchscreen X button to disable
display of the Rear View Camera image is pressed.
Whenever the Rear View Camera image is activated
through the Back Up Camera button in the Controls menu,
and the vehicle speed is greater than, or equal to, 8 mph
(13 km/h), a display timer for the image is initiated. The
image will continue to be displayed until the display timer
exceeds 10 seconds.
NOTE:
If the vehicle speed remains below 8 mph (13 km/h),
the Rear View Camera image will be displayed continu
-
ously until deactivated via the touchscreen X button,
the transmission is shifted into PARK, or the ignition is
placed in the OFF position.
The touchscreen X button to disable display of the
camera image is made available ONLY when the
vehicle is not in REVERSE.
Cargo Camera Icons — If Equipped
If equipped with a Cargo Camera, a touchscreen button is
made available to indicate the current active Camera
image being displayed whenever the Rear View Camera
image is displayed.
If equipped with a Cargo Camera, a touchscreen button to
switch the display to Cargo Camera image is made
available whenever the Rear View Camera image is
displayed.
A touchscreen X button to disable display of the camera
image is made available when the vehicle is not in
REVERSE gear.
When enabled, active guidelines are overlaid on the Back
Up camera image to illustrate the width of the vehicle and
its projected back up path based on the steering wheel
position. The active guidelines will show separate zones
that will help indicate the distance to the rear of the
vehicle. The corresponding settings can be adjusted
Back Up Camera Touchscreen Button
Cargo Camera Touchscreen Button
AUX Camera Touchscreen Button
23_DJD2_OM_EN_USC_t.book Page 190